Wire World Of America 1800 - Manual (Page 17)

11
Note: Your Macintosh computer automatically assigns the name “(en1)” to the Intelligent Gateway USB
port. If your computer has more than one Ethernet-type network device installed, the USB port may be
named “(en2)” or higher.
Check your connections
Power-on your computer. When your computer is fully powered-up, verify the POWER and LOCAL
NETWORK indicator lights on the front of the Intelligent Gateway are green. If they are not, see
“Diagnosing connection problems” on page 110. The BROADBAND LINK indicator light will not turn green
until the Intelligent Gateway software has been installed and an Internet connection has been established.
Continue from here to Step 3 “Install the Intelligent Gateway Software” on page 12.
8. Verify that Ethernet Adaptor (en1) is selected
in the Show field. If it is not, select it from the
pull-down menu. When the New Port Detected
message displays, click
OK .
9. Click Save to complete your installation.