Wire World Of America 1800 - Manual (Page 16)

10
Install the Intelligent Gateway USB driver — Macintosh
Before installing your Intelligent Gateway software, you must install the Intelligent Gateway USB driver
on your computer. The following screens show the installation under Macintosh OS 10.2 and may vary
somewhat on Macintosh OS 8.6 to 9.X.
1. Power on your computer.
2. Insert the Intelligent Gateway Setup Wizard CD
in your computer’s CD-ROM drive.
3. Double-click the 2Wire USB folder to install
the driver.
4. If you have set up an administrator name and
password, the Authenticate screen opens. Enter
your administrator name and password and
click
OK .
5. Follow the on-screen instructions. When the
driver installation is complete, you will be
prompted to restart your computer.
6. After your computer restarts, connect a USB
cable from your Macintosh computer to the
Intelligent Gateway USB port.
7. Establish your connection. Open the network
Control Panel and select the
Apple icon>System Preferences...>Network .