WatchGuard Technologies SOHO - Manual (Page 23)

User Guide 5.0 23
The Default Factory Settings
Firewall Settings
All incoming services are blocked.
An outgoing service allowing all outbound traffic.
None of the Firewall Options are enabled.
The DMZ pass-through is disabled.
System Security
System Security is disabled and no System Administrator
name or passphrase is set–the onboard configuration
pages are available to all on the trusted network.
SOHO Remote Management is disabled.
VPN Manager Access is disabled.
No remote logging is configured.
WebBlocker
WebBlocker is disabled and no settings are configured.
Upgrade Options
No upgrade options are enabled until the certificates have
been redeemed.
Resetting a SOHO to the Factory Defaults
It is possible that due to a firmware corruption or other unforeseen
misfortune (such as a lost System Security passphrase) you may
need to reset the SOHO to the factory defaults.
To do this, you will need to remove the SOHO from your network
disconnect the power, disconnect all cables, plug one end of an
Ethernet cable into the WAN port in the back of the device and the
other end into any of the other four (numbered 1-4) Ethernet ports.
Then, reconnect the power, wait at least 90 seconds, and
disconnect power. Your SOHO is now reset to factory defaults.
Connect the cables in the original configuration and power up
again.