WHP Wireless DL360 - Manual (Page 155)

Troubleshooting 155
Logical Drive X Status = Overheating ....................................................................................... 171
Logical Drive X Status = Recovering (rebuilding data on a replaced drive) ............................. 172
Logical Drive X Status = Wrong Drive Replaced ...................................................................... 172
Loose Cable Detected - Logical Drives May Be Marked FAILED Until Corrected.................. 172
Mirror Data Miscompare ............................................................................................................ 172
No Configuration for Array Accelerator Board.......................................................................... 173
NVRAM Configuration Present, Controller not Detected.......................................................... 173
One or More Drives is Unable to Support Redundant Controller Operation ............................. 173
Other Controller Indicates Different Hardware Model............................................................... 173
Other Controller Indicates Different Firmware Version............................................................. 173
Other Controller Indicates Different Cache Size........................................................................ 174
RIS Copies Between Drives Do Not Match ............................................................................... 174
SCSI Port X Drive ID Y failed - REPLACE (failure message) ................................................. 174
SCSI Port X, Drive ID Y Firmware Needs Upgrading .............................................................. 174
SCSI Port X, Drive ID Y Has Exceeded the Following Threshold(s)........................................ 175
SCSI Port X, Drive ID Y is not Stamped for Monitoring........................................................... 175
SCSI Port X, Drive ID Y May Have a Loose Connection... ...................................................... 175
SCSI Port X, Drive ID Y RIS Copies Within This Drive Do Not Match .................................. 176
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been Detected in the
Factory Monitor and Performance Data... ..................................................................................
176
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been Detected in the
Power Monitor and Performance Data... ....................................................................................
176
SCSI Port X, Drive ID Y Was Replaced On a Good Volume: (failure message) ...................... 176
Set Configuration Command Issued........................................................................................... 177
Soft Firmware Upgrade Required............................................................................................... 177
Storage Enclosure on SCSI Bus X has a Cabling Error (Bus Disabled)... ................................. 177
Storage Enclosure on SCSI Bus X Indicated a Door Alert......................................................... 177
Storage Enclosure on SCSI Bus X Indicated a Power Supply Failure... .................................... 177
Storage Enclosure on SCSI Bus X Indicated an Overheated Condition..................................... 178
Storage Enclosure on SCSI Bus X is Unsupported with its Current Firmware Version... ......... 178
Storage Enclosure on SCSI Bus X Indicated that the Fan Failed... ............................................ 178
Storage Enclosure on SCSI Bus X Indicated that the Fan is Degraded...................................... 179
Storage Enclosure on SCSI Bus X Indicated that the Fan Module is Unplugged... ................... 179
Storage Enclosure on SCSI Bus X - Wide SCSI Transfer Failed............................................... 179
Swapped Cables or Configuration Error Detected. A Configured Array of Drives... ................ 179
Swapped Cables or Configuration Error Detected. A Drive Rearrangement... .......................... 180
Swapped Cables or Configuration Error Detected. An Unsupported Drive Arrangement Was
Attempted... ................................................................................................................................
180
Swapped Cables or Configuration Error Detected. The Cables Appear To Be Interchanged... . 181
Swapped Cables or Configuration Error Detected. The Configuration Information on the