Westell Technologies Versalink 327W - Manual (Page 135)

030-300500 Rev. A 135 October 2006
User Guide VersaLink™ Gateway (Model 327W)
Host not found: The DNS Server was unable to find an address for the given
host name.
No data, enter host name: No host name is specified.
Could not test: The test could not be executed due to VersaLink settings. Check
your DSL sync or your PPP session. You must have both a DSL sync and a PPP
connection established to execute a PING.
IP Address IP Address of the Host Name.
PING
(via IP Address or Host Name)
Performs an IP connectivity check to a remote computer either within or beyond
the Service Provider’s network. You can PING a remote computer via the IP
address or the DNS address. If your PING fails, try a different IP or DNS
address.
Possible responses are:
Success: The Remote Host computer was detected.
No Response: There was no response to the Ping from the remote computer.
No name or address to PING: No host name or IP address was specified.
Could not test: The test could not be executed due to VersaLink settings. Check
your DSL sync or your PPP session. You must have both a DSL sync and a PPP
connection established to execute a PING.
Trace
Determines the route taken to destination by sending Internet Control Message
Protocol (ICMP) echo packets with varying IP Time-To-Live (TTL) values to
the destination. Trace Route is used to determine where the packet is stopped on
the network.
15.2 Diagnostic Logs
If you select Diagnostic Log, from the System Self Test menu, the following screen will be displayed.