Hardware features, 1 led indicators – Westell Technologies Versalink 327W User Manual

Page 9

Advertising
background image

030-300500 Rev. A

9

October 2006

User Guide

VersaLink™ Gateway (Model 327W)

5. HARDWARE FEATURES

5.1 LED Indicators


This section explains the LED States and Descriptions. LED indicators are used to verify the unit’s operation and
status.

LED States and Descriptions

LED State

Description

Solid Green

Modem power is ON.

OFF

Modem power is OFF.

POWER

Solid Red

POST (Power On Self Test), Failure (not bootable) or Device
Malfunction. NOTE: The Power LED should be red no longer
than two seconds after the power on self test passes.

Solid Green

Powered device is connected to the associated port (includes
devices with wake-on LAN capability where slight voltage is
supplied to an Ethernet connection).
NOTE: When using the optional uplink port (E1), Ethernet LAN
connection is limited to E2, E3, and E4.

Flashing Green

10/100 Base-T LAN activity is present (traffic in either direction)

ETHERNET

(E1, E2, E3, E4)

OFF

Modem power is OFF, no cable or no powered device is
connected to the associated port.

Solid Green

Link Established.

Flashing Green

Wireless LAN activity is present (traffic in either direction).

WIRELESS

OFF

Modem power is OFF or No Link.

Solid Green

Good DSL sync.

Flashing Green

DSL attempting to sync.

DSL

OFF

Modem power is OFF.

Solid Green

Internet link established.

Flashing Green

IP connection established and IP Traffic is passing through
device (in either direction).
NOTE: If the IP or PPP session is dropped due to an idle timeout,
the light will remain solid green, if an ADSL connection is still
present.
If the session is dropped for any other reason, the light is turned
OFF. The light will turn red when it attempts to reconnect and
DHCP or PPP fails).

Solid Red

Device attempted to become IP connected and failed (no DHCP
response, no PPP response, PPP authentication failed, no IP
address from IPCP, etc.).

INTERNET

OFF

Modem power is OFF, Modem is in Bridge Mode, or the
connection is not present.

NOTE: Safe Boot is reflected when the Power and Internet LEDs are both Red and all other LEDs are off.








Advertising