Westell Technologies Versalink 327W User Manual
Page 15
030-300500 Rev. A
15
October 2006
User Guide
VersaLink™ Gateway (Model 327W)
5.
Connect the DSL phone cable from the connector marked
on the rear panel of VersaLink to the DSL-
equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must
use the phone cord that was provided with the VersaLink kit.
6.
Check to see if the DSL LED is solid Green. If the DSL LED is solid Green, VersaLink is functioning properly.
7.
Check to see if VersaLink’s Wireless LED is solid Green. This means that the Wireless interface is functioning
properly.
Congratulations! You have completed the Wireless installation VersaLink. You must now go to section 7 to
configure VersaLink for Internet connection.
Figure 2. Connection via Wireless