Weslo Daybreak SPRW52464 - Manual (Page 8)

8
1. Before beginning assembly, be sure that you
have read and understand the information in the
box above and on the previous page.
Press a Floor Cap (2) onto the bottom of each of the
eight Side Panels (1). Be sure to align the indicat-
ed holes. The Side Panels must be oriented and
fully inserted in the Floor Caps as shown in the
inset drawing.
2. Slide an Angle Bracket (3) between one of the Side
Panels (1) and the Floor Cap (2), as shown. Attach
the Angle Bracket to the Side Panel with a Bracket
Screw (4).
Attach an Angle Bracket (3) to each of the remaining
Side Panels (1) in the same manner.
3. Slide two of the Side Panels (1) together as shown.
The indicated Angle Bracket (3) should go
between the Side Panel and the Floor Cap (2).
Slide a Connector Bracket (6) into the Side Brackets
(5). Attach the Angle Bracket to the other Side Panel
with a Bracket Screw (4).
Continue to connect the remaining Side Panels (1) in
the same manner.
3
1
1
3
4
2
1
2
Align
these
holes
Align these holes
2
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
¥ Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
¥ Assembly requires two people.
¥ Tighten all parts as you assemble them, unless
instructed to do otherwise.
¥ Read each assembly step before you begin.
¥ During assembly, make sure that all parts are ori-
ented as shown in the drawings.
TOOLS REQUIRED FOR ASSEMBLY:
¥ Your own phillips screwdriver
¥ The included allen wrench
¥ You may also need a hammer
1
3
5
6
4
2
1
1
Wood Foam
2