Weslo Daybreak SPRW52464 - Manual (Page 9)

9
4. Place the Insulated Floor Cover (8) inside the
assembled Side Panels (1). The edge of the
Insulated Floor Cover should cover the bottom two
inches of the Side Panels (see the inset drawing).
Measure the width of the DAYBREAK, from the top
center of one Side Panel (1) to the top center of the
Side Panel directly across from it. Take two mea-
surements, as shown. Both measurements must
be the same. The measurement should be
between 56Ó and 58Ó. If the frame is not squared,
the Spa Cover (not shown) will not fit properly. If
necessary, adjust the positions of the Side Panels
so the frame is squared.
5. Place the Spa Liner (9) on top of the Insulated
Floor Cover (8). Smooth out the Spa Liner, working
the wrinkles to the edges. The seam in the Spa
Liner should be lined up with a joint between two of
the Side Panels (1).
Stretch the edge of the Spa Liner (9) over the top of
the Side Panels (1), working the wrinkles to the top.
The edge of the Spa Liner should hang over the
Side Panels about two inches.
6. Place the Small Edge Protector (14) on top of the
Side Panel (1) closest to the electrical outlet which
you will use to power the DAYBREAK. This is the
Side Panel where the Spa Jet Unit (not shown)
will be placed.
Place the seven Edge Protectors (12) around the
top of the remaining Side Panels (1).
7. Remove the power cord from the Spa Jet Unit (13).
Place the Spa Jet Unit over the Side Panel (1) with
the Small Edge Protector (14). Be extremely care-
ful not to tear the Spa Liner (9) as you slide the
Spa Jet Unit into place.
6
4
8
1
1
Both
measurements
must be equal
1
14 12
9
Seam
1
8
5
1
8
7
13
14
Power
Cord
1
9