Westell Technologies 2200 - Manual (Page 10)

030-300354 Rev. B 6 July 2003
Section 5-Installing the Hardware
Westell Dual Connect NAT Router User Guide
5.4.1 Router Installation via 10/100 Base-T Ethernet
NOTE: Before you connect the Dual Connect NAT Router via 10/100 Base-T, you must have an available
Ethernet card installed in your computer. If your Ethernet card does not auto-negotiate, you must set it to
half duplex. Refer to the Ethernet card manufacturer’s instructions for installing and configuring your
Ethernet card. If you do not have an Ethernet card installed in your computer, go to section 5.4.2.
Refer to Figure 1.
1. Connect the power supply cord to the power connector marked
~
on the rear panel of the Router. Plug the
other end of the power supply into an AC wall socket.
2. Connect the DSL phone cable from the jack marked on the rear panel of the Router to the DSL-equipped
telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the
phone cord that was provided with the Router kit.
3. Connect the Ethernet cable from the Ethernet jack marked on the rear panel of the Router to the Ethernet
port on your computer.
Congratulations! You have completed the Ethernet hardware installation for your Dual Connect NAT Router. No
software installation is required when using an Ethernet connection. You must now proceed to step 7.
Figure 1. Connection via 10/100 Base-T Ethernet
!
12V