Westell Technologies 2200 - Manual (Page 107)

030-300354 Rev. B 103 July 2003
Section 15-Troubleshooting
Westell Dual Connect NAT Router User Guide
the Service Provider’s network. You can PING a remote computer via the IP
address or the DNS address. If your PING fails, try a different IP or DNS address.
Possible responses are:
Success: The Remote Host computer was detected.
No Response: There was no response to the Ping from the remote computer.
No name or address to PING: No host name or IP address was specified.
Could not test: The test could not be executed due to Router settings. Check your
DSL sync or your PPP session. You must have both a DSL sync and a PPP
connection established to execute a PING.
Trace Route Determines the route taken to destination by sending Internet Control Message
Protocol (ICMP) echo packets with varying IP Time-To-Live (TTL) values to the
destination. Trace Route is used to determine where the packet is stopped on the
network.
15.2 Diagnostic Logs
If you select Diagnostic Log, from the System Self Test menu, the following screen will be displayed.