Westell Technologies Westell UltraLine 7400 - Manual (Page 147)

030-300381 Rev. A 147 January 2004
User Guide
UltraLine Home DSL Router (Models 7400, 7401)
S
Single Static IP
This page contains the settings that would allow the PPP address received from the network to be propagated to a
single LAN device behind the Router.
Single Static IP
WAN IP Address This is the PPP IP address the ISP has assigned the Router.
Selection box This box contains the devices available to share the Single Static IP address the
ISP has assigned the Router. The names listed in the select box will be
populated by the Router’s DHCP server based on DHCP requests. If a device’s
name cannot be determined, the current IP address of the device will be placed
in the list.
When the feature is enabled, the active machine will be highlighted in the select
box and be displayed at the bottom of the page with the “disable” button.
When the feature is disabled, no device in the select box will be highlighted and
the “enable” button will be available.
When the “User Configured PC” is selected, a local PC must be configured
manually with the WAN IP address as its Ethernet adapter’s address.
T
Trace Route
The Trace feature allows you to perform an IP trace route to a remote computer either within or beyond the Internet
service provider’s network. Enter either the IP address or the hostname of the remote host computer into the input
box to the right of the Trace button. If you trace by name, DNS will be used to look up the appropriate IP address for
that name.
Trace
Success Trace will display its progress in the text box. Trace will show three round trip
times and the DNS name (if available) of each intermediate router.
Failure Trace will display “*” when it does not receive a response or cannot determine
the DNS name of an intermediate router. This is not necessarily an error, as
some routers are configured to ignore trace route packets or do not have DNS
name.