Westell Technologies Westell UltraLine 7400 - Manual (Page 96)

030-300381 Rev. A 96 January 2004
UltraLine Home DSL Router (Models 7400, 7401)
User Guide
12.5.4 Route
The following settings will be displayed if you select Route from the Advanced WAN menu.
To add a Route, enter a Netmask address, or check the Host Route box. Click on the add button to establish a static
route.
IP Interfaces
IP Interfaces The list of active interfaces on the Router and their IP address and mask.
Eth0 is the local LAN interface.
Lo0 is the loopback interface.
MainPPP is the main protocol interface.
Address The IP interface address.
Netmask The IP interface netmask address.
Name The IP interface device name.
Network Routing Table
Network Routing Table The list of network routes. These can be either routes for directly connected
interfaces or static routes.
Destination Address The IP address or subnet of the Route.
Netmask If the Route is a network route, netmask is used to specify the subnet mask.
If the Route is a Host route, then the Host Route check box is used.
Gateway Indicates were to send the packet if it matches this route.