weber 3400 Series - Manual (Page 17)

17
Hose and regulator
Slot in frame brace
Frame brace
(a)
(b)
Tabs on tank panel
Cross brace
Side burner hose
Side burner
hose
Step 14
Install tank panel assembly
You will need: tank panel assembly.
Slide the side burner back. Insert the tabs into the slots in
the frame brace at the wheel legs. (Make sure the side
burner hose is to the front of the barbecue.) Figure 16 (a).
Slide up until the notch at the bottom of the tank panel fits
over the cross brace. Figure 16 (b).
Step 15
Install right end panel
You will need: right end panel (Number 3), 1/4-20 x
1 1/2 inch bolt, 1/4-20 hex nut, two nylon washers and a
7/16 inch wrench.
Set the right end panel in place with the flange at the top
facing away from the barbecue, and the bottom flange
under the frame brace. Figure 17.
Make sure the gas supply hose is on the outside of the
panel. Put washer on bolt and insert bolt through both
panels and frame brace. Add washer and hex nut and
tighten. Figure 17.
Figure 16
Figure 17