weber 3400 Series - Manual (Page 19)

19
Figure 21
Figure 22
Slot in frame
(view from below)
(c)
View from rear
of barbecue
Hinge rod
(b)
(a)
Figure 23
(a)
(b) (c)
Support rod
Step 19
Check that all burner valves are off
You will need: one burner control knob.
(Valves are shipped in the OFF position, but you should
check to be sure.) Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn,
they are off, proceed to the next step. Figure 21.
Insert one end of the hinge rod into the hole in the frame.
Figure 23 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 23 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 23 (c).
To fully seat the bracket, you may have to tap it lightly with
a hammer.
ƽ
WARNING: If swing table end bracket is in any way
cracked or damaged, do not use swing table. Call your
dealer to order a new part.
ƽ
WARNING: The load limit for the swing table is
30 pounds.
Step 20
Install left hand swing table
You will need: swing table end bracket, two 10-24 hex
nuts, two 10-24 x 1 3/4 inch machine screws, left hand
slide bar assembly, swing table, four nylon washers,
screwdriver and pliers.
Allow the slide bar to hang down. Push the support rod
into the lower support bracket. Figure 22 (a). Swing the
rod up so you can slide the rod all the way inside the
locking tab. Figure 22 (b). The rod should swing freely
inside the locking tab. Figure 22 (c).