weber 3400 Series - Manual (Page 29)

29 29
6
7
2
8
4
1
3
5
Figure 2
Manual Lighting
4) Turn the tank on by turning the tank valve
counterclockwise.
5) Strike a match and put the flame into the matchlight
hole in the front of the cooking box.
ƽ
WARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.
6) Push Front burner control knob down and turn to
START/HI.
7) Check that the burner is lit by looking through the
matchlight hole on the front of the cooking box.
ƽ
WARNING: If the burner does not light, turn the Front
burner control knob to OFF and wait 5 minutes to let
the gas clear before you try again or try to light with a
match.
8) After the FRONT burner is lit you can turn on the other
burners.
Note - Always light the FRONT burner first. The other
burners ignite from the FRONT burner.
To Extinguish
Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.
Manual Lighting
ƽ
DANGER
Failure to open lid while igniting the
barbecue, or not waiting 5 minutes to
allow the gas to clear if the barbecue
does not light, may result in an explosive
flame-up which can cause serious bodily
injury or death.
ƽ
DANGER
When the excess flow control is
activated, a small amount of gas is still
flowing to the burners. After turning OFF
the tank and burner control knobs, wait
at least 5 minutes for the gas to clear
before attempting to light the barbecue.
Failure to do so may result in an
explosive flame-up which can cause
serious bodily injury or death.
1) Open the lid. Figure 2.
2) Check that fuel scale reads more than “E”.
Note - E = empty; F = full.
3) Make sure all burner control knobs are turned OFF.
(Push each burner control knob down and turn
clockwise.)
ƽ
WARNING: The burner control knobs must be in the
OFF position before turning on the LP tank valve. If
they are not in the OFF position, when you turn on the
LP tank valve, the excess flow control will activate,
limiting the flow of gas from the LP tank. If this should
occur, turn OFF the LP tank valve and burner control
knobs and start over.