Yamaha CC-5 - Manual (Page 15)

CD playback
1
Select the CD position.
2
Press the open/close button to open the disc table.
3
Place a disc on the table, label side up.
*
8 cm (3”) discs may be played without an adaptor.
4
Press the open/close button to close the disc table.
*
The total number of tracks and the total playing time
will be displayed for several seconds.
* The music schedule will be displayed only for the
number of tracks on the disc.
* If the compact disc contains more than 21 tracks, the
“OVER” indicator will light up on the music schedule.
5
Press the play button to start playback from track 1.
*
The “ ” indicator will appear and playback will begin.
As the playback of each track on the music schedule is
finished, that track number will go out.
Direct playback
If a compact disc is already in the disc table, just press the
play button to automatically turn on the power and start
playback.
To interrupt playback
1 1
Press the pause button.
*
The “ ” indicator will light up.
2 2
Press the play button to resume playback from the same
point.
To stop playback
Press the stop “ ” button.
To switch the unit off after use
Set the unit to the STANDBY mode by pressing POWER
switch. (The indicators will go off except for the STANDBY
indicator and the current time display.)
COMPACT DISC OPERATION
1 2 3 4 5
6 7 8 9 0
CLEAR CALL + TIME PROG
REPEAT CD
BAND TUNER
HALL JAZZ CLUB ROCK CNCT OFF
POWER AUX DAT VOLUME
TAPE
-
b
a
10
+
E-13
REMAIN
1 2 3
11 12
4 5 6 7 8 9 10 1 2 3
11 12
4 5 6 7 8 9 10
TOTAL
2,4 5
POWER 1
1 1 2,4
1
5,
2 2
POWER
Total number
of tracks
Total playing time
Remaining playing
time for first track
Music schedule