Yamaha CC-5 - Manual (Page 32)

1 2 3 4 5
6 7 8 9 0
CLEAR CALL + TIME PROG
REPEAT CD
BAND TUNER
HALL JAZZ CLUB ROCK CNCT OFF
POWER AUX DAT VOLUME
TAPE
-
b
a
10
+
E-30
Recording from the built-in tuner
1
Tune to the desired station. (Refer to the “TUNER
OPERATION” on page 19.)
2
Load a tape into the tape “b” cassette compartment.
3
When recording with the Dolby NR system, set the
DOLBY NR switch to B or C; if not, set it to OFF.
*
For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 24.
4
Set the REVERSE MODE switch to to record on only
one side, or to for continuous recording on both sides.
5
Press the REC button.
*
The indicator beside the REC button lights up and the
play indicators flash.
6
Press the play button to record side A, or the play
button to record side B.
*
For continuous recording of both sides, begin on side
A. Recording stops automatically at the end of side B.
To stop recording temporarily
1 1
Press the PAUSE button.
2 2
To resume recording, press the play button whose
indicator is flashing.
To stop recording
Press the stop button.
Erasing recorded tapes
1
Load the tape to be erased into the tape “b” cassette
compartment.
2
Select the AUX position with the INPUT selector.
3
Set the REVERSE MODE switch to to erase only one
side and to to erase both sides.
4
Press the REC button, then press the play button to
erase side A of tape, or the play button to erase side B.
RECORDING
4 3 1 1 5 6
2
5, 1 1
6, 2 2