Yamaha CC-5 - Manual (Page 25)

1 2 3 4 5
6 7 8 9 0
CLEAR CALL + TIME PROG
REPEAT CD
BAND TUNER
HALL JAZZ CLUB ROCK CNCT OFF
POWER AUX DAT VOLUME
TAPE
-
b
a
10
+
E-23
Direct playback
If a cassette tape is already in the cassette compartment, just
press the play button to automatically turn on the power and
start playback.
Note
While the INPUT selector is rotating to select the TAPE
position before playback starts, do not press the EJECT
button.
To stop playback
Press the stop button.
Note
When removing the cassette tape, press the stop button,
and then open the cassette compartment.
To switch the unit off after use
Set the unit to the STANDBY mode by pressing the POWER
switch. (The indicators will go off except for the STANDBY
indicator and the current time display.)
Winding the tape
1
First press the stop button.
2
Next press the or button to wind the tape.
3
Press the stop button to stop.
Searching for the beginning of a
desired selection
Carry out the following operation during playback to find the
beginning of a desired selection on the tape.
• To listen to the same selection, press the or
button in the direction opposite from that of current
playback.
•
To listen to the next selection, press the or button
in the same direction as that of current playback.
Notes
This function may not work for tapes with
•
Material with long pauses or quiet passages.
•
Low recording levels or excessive noise.
•
Pauses of less than 3 seconds between selections.
CASSETTE TAPE OPERATION
(a)
(a)
(b)
(b)