Zenith HD-SAT520 - Manual (Page 36)

4. FRONT PANEL AND REMOTE CONTROL
4-2. Using the Remote Control
Power
Turns the DIRECTV ® High-Definition Receiver on and off. If your
remote control is programmed to control other components such as
VCR, DVD, etc., Power will turn the component on and off. If you
want to control other components from different manufacturers, you
must first program your remote control. For further instructions on
remote control programming, please refer to the section 4.3 of this
operating guide or the Program Remote section of on-screen help.
Mode
Selects the device that will be controlled by the remote. For exam-
ple, if your remote control is set to VCR, the CH +/- button will
change the channel number of the VCR. If you want to control other
devices from different manufacturers, you must first program your
remote control.
Digit Buttons (0~9)
Allows you to enter channel numbers for direct tuning or to scroll to
the designated page of the program list on the Guide menu. Digit
buttons can be used to enter numerical values wherever required
e.g. to enter a password.
Dash (-)
Is used to enter a channel number for multiple program channels
such as 2-1, 2-2, etc. A broadcaster may transmit multiple programs
on a single channel. Multiple programs are distinguished by a
unique sub-channel number, separated by a dash (-).
Sel ( ) [Select]
Use with numbered buttons for instant channel selection. When you
press a channel number, for example, 22, the receiver awaits anoth-
er stroke for three seconds and then tunes to 22.
Mute
Is used to temporarily turn off the sound. Press again to restore the
sound.
Vol +/-
Increases/decreases the sound level of the DIRECTV HD Receiver.
1 2 3
4 5 6
7 8 9
0
power
sat vcr aux
tv dvd
mute
signal sd/hd flashbk cc/date
menu
help
record stop skip
pause rew play ff
exit
guide surf
info
vol ch
pg up
pg dn
ratio
1
2
3
4
5
1
2
3
4 5
6
7
6
7
35
206-3813