Yamaha RP-U100 - Manual (Page 11)

6
Connecting Audio Equipment
The following illustration shows how to connect a CD player and MD or tape recorder.
The CD player is shown connected to the RP-U100 using both analog and digital connec-
tions. However, it’s not necessary to make both connections. Since digital offers higher
quality, use the digital connection if your CD player had a digital output. The MD/tape
recorder is shown connected to the RP-U100 using analog and digital connections. If your
MD player has a digital input, connect it as shown. Be careful not to mix up the left and
right connections.
Protective Caps
When connecting to an optical connector,
remove its protective cap first. When an
optical connector is not being used,
replace its cap to prevent dust entering the
connector.
Note: The DIGITAL AUX 1 OPT IN has priority over the ANALOG AUX 1 IN, so if you
connect to both inputs, the signal received at the DIGITAL AUX 1 OPT IN is used.
DIGITAL
OUT
(OPTICAL)
DIGITAL
IN
(OPTICAL)
ANALOG
PC IN
AUX 1
IN
SUB WOOFER OUT
IN
OUT
AUX 2
R L
ANTENNA
AM
FM
75 Ω UNBAL
GND
DIGITAL
SPEAKERS
6 Ω MIN./SPEAKER
+
–
USB
OPT OUT
AUX 1
OPT IN
COAX IN
PC
OPT IN
R L
LINE OUT
LINE IN
(REC) LINE OUT
(PLAY)
CD player
MD/tape recorder
PC IN
AUX 1
IN
IN
OUT
AUX 2
R L
OPT OUT
AUX 1
OPT IN