Yamaha RP-U100 - Manual (Page 15)

10
Selecting Audio Sources
This section explains how to turn on the
RP-U100 and select input sources.
If any external audio equipment is con-
nected to the RP-U100, turn it on first.
1. Press the POWER switch to turn
on the RP-U100.
The message “Hello” appears for
a few seconds, and the RP-U100
returns to the state in which it was last
used (e.g., the input source that was
selected when the RP-U100 was turned
off is selected).
2. Use the input selector keys to select
one of the following input sources.
• PC
Press the PC key repeatedly to select the
following PC inputs: USB, PC_DG, and
PC_AN. USB select the USB port, PC_DG
selects the DIGITAL PC COAX IN and
DIGITAL PC OPT IN, and PC_AN selects
the ANALOG PC IN.
Note: The DIGITAL PC OPT IN has
priority over the DIGITAL PC COAX
IN, so if you connect to both inputs, the
signal received at the DIGITAL PC
OPT IN is used.
• AUX1
Press the AUX1 key to select the equip-
ment connected to the ANALOG AUX 1
IN or DIGITAL AUX 1 OPT IN connector
as the input source.
Note: The DIGITAL AUX 1 OPT IN
has priority over the ANALOG AUX 1
IN, so if you connect to both inputs, the
signal received at the DIGITAL AUX 1
OPT IN is used.
• AUX2
Press the AUX2 key to select the equip-
ment connected to the ANALOG AUX 2
IN connectors as the input source.
• TUNER
Press this key repeatedly to select the fol-
lowing tuner bands: FM Auto Stereo, FM
Mono, or AM.
3. Start the selected input source.
See page 11 for more information
about using the tuner.
4. Use the volume control to adjust the
volume level.
PC
AUX1
AUX2
TUNER
VIRTUAL
USB
FM
VOL
AM ST MEMORY
DSP
PCM DD
P C _ A N
VIRTUAL
USB
FM
VOL
AM ST MEMORY
DSP
PCM DD
P C _ D G
VIRTUAL
USB
FM
VOL
AM ST MEMORY
DSP
PCM DD
U S B D G
PC
PC PC
PC (digital)
PC (analog)
PC i USB j
VIRTUAL
USB
FM
VOL
AM ST MEMORY
DSP
PCM DD
9 2 . 5 0