Yamaha Plug-in Effect mLAN16E - Manual (Page 17)

17 TOOLS for i88X/mLAN16E, Plug-in Effect Installation Guide
English
e Status
If you are using mLAN Auto Connector, this
parameter indicates the current data (MIDI/
Audio) reception status (from the mLAN device
to computer) of the mLAN connection. If there
is an error in transmission, the computer
displays an error message.
If you are using mLAN Graphic Patchbay, refer
to the Graphic Patchbay Online Manual for
information on the error messages.
Blue ....... Data is being properly transmitted.
Yellow ... Only one type of data (MIDI or
audio) is being received.
Red ........ Error in reception.
Gray....... No reception.
r Set
Clicking this button actually applies the settings
made in this window. Changes to the settings do
not take effect unless [Set] is clicked.
t Revert
If you’ve made changes to the settings (but not
yet clicked [Set]), clicking this button restores
the settings made the last time [Set] was clicked.
Once you click [Set], [Revert] cannot be used.
y EXIT
Click to close the dialog box.
About the Information window
This window indicates the MIDI and audio data reception status (from the mLAN device to computer).
R1, R2, etc.
This indicates the data reception status. “R1” corresponds to
MIDI reception while “R2 corresponds to audio reception from
the mLAN device. The number of tabs shown differs
depending on your particular computer configuration.
Icon
Blue ........ Reception is normal.
Red......... Error in reception.
Gray........ No reception.
Receive Status
This mark indicates the order in which the data of each format is received. The
symbol “o” indicates that data in the corresponding format is being received. The
symbol “-” indicates that data in a different format is being received. For example, the
symbol “oooooooo-” in the “Audio” field indicates that nine sequences have been
received, and the first eight sequences are in the audio data format. The “Unknown”
field displays symbols if sequences in unknown formats are received. These fields
are blank if no mLAN data is received. If an error occurs during reception, a red
warning message flashes. In this case, check the transmission device.