Yamaha Plug-in Effect mLAN16E - Manual (Page 19)

19 TOOLS for i88X/mLAN16E, Plug-in Effect Installation Guide
English
Connecting a Computer to an mLAN device via mLAN
This section describes the procedure for
connecting a computer to a single mLAN device
peer-to-peer in mLAN Auto Connector.
In mLAN Auto Connector, you can easily
connect an mLAN device by setting up the
wordclock and the number of audio I/O
channels.
To connect multiple mLAN devices to a
computer, use mLAN Graphic Patchbay. For
more information on mLAN Graphic Patchbay,
refer to the mLAN Graphic Patchbay Online
Manual.
• Noise may be generated when you connect an mLAN
device in mLAN Auto Connector. Before you make
connections in mLAN Auto Connector, lower the vol-
ume level of the connected device.
• If you use Auto Connector after you make connections
in mLAN Graphic Patchbay, the connections made in
mLAN Graphic Patchbay will be cancelled.
• You can also use mLAN Graphic Patchbay to connect
a computer to a single mLAN device peer-to-peer.
• The mLAN Auto Connector windows may appear dif-
ferent when certain mLAN devices are connected.
1
Connect a computer to an mLAN device using
an IEEE1394 cable.
2
Right-click the YAMAHA mLAN Manager icon
in the Task bar, then select [Auto Connector].
3
Set up the wordclock and specify the number
of audio channels (see below), then click the
[Connect] button. The computer and mLAN
device are connected via mLAN.
Connecting the i88X
q
w
t
u
!1 !2 !0
e
r
y
i
o