Zanussi ZYB992 User Manual

Page 16

Advertising
background image

Cleaning the door gasket

• Regularly do a check of the door gasket. The door gas-

ket is around the frame of the oven cavity. Do not use

the appliance if the door gasket is damaged. Contact

the Service Centre.

• To clean the door gasket refer to the general informa-

tion about the cleaning.

Pyrolytic cleaning

Warning! The appliance becomes very hot. There is

the risk of burns.

Important! Do not use Pyrolytic cleaning function and the

hob at the same time (if it is installed with the appliance).

It can cause a damage to the appliance.
Before Pyrolytic cleaning:
1. Remove all removable parts from the appliance.
2. Remove the worst of the dirt manually.
3. Close the oven door correctly.
Using the Pyrolytic cleaning
1. Press again and again until the display shows

.

– The display shows PYRO 1 or PYRO 2.
– In 3 seconds the display shows a message to re-

move all removable parts from the appliance.

2. While Duration flashes, press or to set the

duration for the Pyrolytic cleaning:
– 2:00 for a low degree of dirt
– 2:30 for a high degree of dirt.

3. Press to start the Pyrolytic cleaning.
The bars on the symbol come on one by one to show

that the temperature in the appliance increases.

When the appliance is at the preset temperature, the door
locks and the display shows .

When the Pyrolytic cleaning is completed, the display

shows the time of day. The oven door is locked. When the

appliance cools down, an acoustic signal sounds and the

door unlocks.

To stop the pyrolytic cleaning at any time, press

.

End time for Pyrolytic cleaning

You can set the end time for Pyrolytic cleaning with
the clock function End .

1. Do again step 1, 2 and 3 from above procedure.
2. Press .
3. The display shows an arrow and the symbol .

The display shows the time for the end of Pyrolytic

cleaning.

4. Press or to adjust the time for the end of the

Pyrolytic cleaning.

Oven lamp

Warning! Be careful! There is the risk of electrical

shock!

Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-

cuit breaker.

Put a cloth on the bottom of the oven for protection

of the oven light and glass cover.

1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C

heat-resistant oven light bulb.

Use the same oven lamp type.

4. Install the glass cover.

Cleaning the oven door

The oven door has four panels of glass. You can remove

the oven door and the internal panels of glass to clean

them.

The oven door can close if you try to remove the

panels of glass before you remove the oven door.

Removing the oven door and the glass panels

1

Open the door fully

and hold the two door

hinges.

2

Lift and turn the levers

on the two hinges.

16

Advertising