Zanussi ZYB992 - Manual (Page 8)

Oven Function Application
Pyro To remove stubborn dirt.
Heat indicator
The Heat indicator shows in the display. It increases
slowly and shows how high the temperature gets.
Rapid Heat-up function
With the Rapid Heat-up function you decrease the pre-
heating time. You can use it with each cooking function.
Important! Do not put the food into the oven, until the
Rapid Heat-up function is completed.
1. Set an oven function.
If necessary, change the recommended temperature.
2. Press . The display shows "FHU" and the Rapid
Heat-up function operates.
3. When the Rapid Heat-up function is completed, an
acoustic signal sounds and "FHU" goes out.
The appliance continues to operate using the set oven
function and oven temperature.
4. Put the food in the oven.
Residual Heat function
With Duration function, the oven automatically switches
off some minutes before the time period is completed. The
oven uses the residual heat to complete the cooking with-
out energy consumption.
Important! Residual heat function is applicable only if the
Duration is more than 15 minutes.
Clock functions
Clock function Application
Time of day Shows the time. To set, change or check the time.
Minute minder To set a countdown time.
A signal sounds, after the time period is completed.
This function has no effect on the operation of the oven.
Duration To set how long the oven has to be in operation.
End To set the switch-off time for an oven function.
Duration and End can be used at the same
time, if the oven is to be switched on and off auto-
matically later. In this case first set Duration , then
End .
8