Zanussi ZYB992 - Manual (Page 18)

Problem Possible cause Remedy
The clock is not set. Set the clock.
The necessary settings are not set. Do a check of the settings.
The automatic switch-off is on. Refer to "Automatic switch-off".
The Child lock is on. Refer to "Deactivating the Child Lock".
The fuse in the fuse box is released. Do a check of the fuse.
If the fuse is released more than one
time, contact a qualified electrician.
The oven lamp does not oper-
ate.
The oven lamp is defective. Replace the oven lamp.
Steam and condensation col-
lect on the food and in the ap-
pliance.
You left the dish in the appliance for too
long.
Do not let the dishes stay in the appli-
ance for longer than 15-20 minutes after
the cooking is completed.
The display shows or
, the appliance does not heat
up and there is no air circula-
tion.
Demo mode is on. Deactivate the appliance. Press for
approximately 2 seconds. An acoustic
signal sounds. Press and hold the but-
tons and at the same time until
the acoustic signal sounds and the indi-
cator goes out.
The display shows the error
code "F...".
There is an electronic error. Write down the error code and contact
the Service Centre.
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
Installation
Warning! Refer to "Safety information" chapter.
18