Zenith LMG340 - Manual (Page 9)

9
BEFORE OPERA
TION
11
Press CLOCK.
(If the clock requires setting, press and hold
CLOCK for more than 2 seconds.)
- The hours display begins to blink.
22
. Select either the 24 hour cycle or the 12 hour
cycle with the MULTI JOG SHUTTLE.
33
Press SET to confirm the selected hour cycle.
44
Use MULTI JOG SHUTTLE to set the current
hour.
55
Press SET.
66
. Use MULTI JOG SHUTTLE to set current
minutes.
77
Press SET and the correct time is shown on
the display.
88
Press CLOCK at any time to show the time on
the display, for about 5 seconds.
(12HR) (24HR) or
When the sleep timer is set, the unit automatically turns off after the specified time has elapsed.
11
To specify the time delay before the power is
turned off, press SLEEP.
In the display window you can see for
about 5 seconds. This means that the system
turns off automatically after 90 minutes.
Each time the button is pressed the time interval
before it turns off is reduced by 10 minutes. i.e.
80...70... etc.
Select the desired time to turn off.
22
To check the remaining time until the power is
turned off.
While the sleep function is active press SLEEP
briefly. The time remaining until the unit turns off
is displayed for about 5 seconds.
ote
If you press SLEEP while the sleep time is displayed,
the SLEEP time is reset.
To cancel Sleep Timer setting
If you wish to stop the function, press the SLEEP button
repeatedly until 10 appears, and then press SLEEP
once again after 10 shows on the display.
Sleep Timer Function
Setting the CLOCK
You can sing along with a music source by connecting a
microphone to the unit.
11
Connect your microphone (not supplied) to the
MIC jack.
22
Play the song you want to sing along with.
33
Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOLUME KNOB.
For your reference
You can record using a microphone.
Refer to the “Recording” explanation section.
otes
• When not using the microphone, set the MIC volume
knob to minimum or turn off the MIC and remove the
microphone from the MIC jack.
• If the microphone is set too near the speaker, a
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level with the MIC volume control.
• If the sound through the microphone is extremely loud,
it may be distorted. In this case, turn the MIC volume
control toward minimum.
Using Microphone