ZyXEL Communications Prestige 650HW - Manual (Page 35)

Prestige 650HW ADSL Router User’s Guide
Hardware Installation and Initial Setup 2-7
2.6 Turning On Your Prestige
At this point, you should have connected the ADSL line, the Ethernet port and the power port to the
appropriate devices or lines. Push in the power button (located on the back of your Prestige) to turn on your
Prestige.
2.7 Configuring Your Prestige For Internet Access
Configure your Prestige for Internet access using:
Web configurator (refer to the Read Me First).
SMT (System Management Terminal). Access the SMT via LAN or WAN using Telnet.
2.7.1 Connect to your Prestige Using Telnet
The following procedure details how to telnet into your Prestige.
Step 1. In Windows, click Start (usually in the bottom left corner), Run and then type “telnet
192.168.1.1” (the default IP address) and click OK.
Step 2. Enter “1234” in the Password field.
Step 3. After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period) after you log in,
your Prestige will automatically log you out. You will then have to telnet into the Prestige again.
2.7.2 Connect to your Prestige Using the Web Configurator
Step 1. Launch your web browser.
Step 2. Enter “192.168.1.1” as the URL.
Step 3. In the User Name field, type "admin". In the Password field, type “1234”. Click OK.
Click the Help button for online web configurator HTML help.
The remainder of this user’s guide shows you how to configure the Prestige for Internet access using SMT
screens. There are also some sections in this guide that also focus on using Telnet to configure the Prestige.
2.7.3 Entering Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.
For your first login, enter the default password “1234”. As you type the password, the screen displays an
“*” for each character you type.