ZyXEL Communications Prestige 650HW - Manual (Page 51)

Prestige 650HW ADSL Router User’s Guide
Internet Access 3-7
Figure 3-5 Menu 3.2.1 — IP Alias Setup
Follow the instructions in the following table to configure IP Alias parameters.
Table 3-1 IP Alias Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Alias Choose Yes to configure the LAN network for the Prestige. Yes
IP Address Enter the IP address of your Prestige in dotted decimal notation 192.168.2.1
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the Prestige
255.255.255.0
RIP Direction Press [ SPACE BAR ] to select the RIP direction. Choices are None,
Both, In Only or Out Only.
None
Version Press [ SPACE BAR] to select the RIP version. Choices are RIP-1,
RIP-2B or RIP-2M.
RIP-1
Incoming
Protocol Filters Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the Prestige.
Outgoing
Protocol Filters Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the Prestige.
When you have completed this menu, press [ ENTER ] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ ESC ] at any time to cancel.
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.