Yamaha H11 - Manual (Page 47)

ENGLISH
Message List
H11 Owner’s Manual
47
Message List
In this chart, the comments are divided into two different parts: The initial sentence explains the meaning of the message
or the underlying problem and the “
→ ” mark indicates the possible solution.
* When the message is a three-digit number (001-052), “Err” (Error) flashes alternately in the display with the number.
* When an operation (such as saving or data transfer) is in process, the display shows a sequence of flashing dashes.
Message* Comment
0 0 1 Indicates failure in accessing the USB flash memory or media.
→Use another USB flash memory or media.
0 0 2 Indicates that the song data cannot be loaded correctly.
The file format is invalid.
→Check the file format.
0 0 4 Indicates that the song data is too large to be loaded.
Indicates that the protected song data cannot be loaded.
0 0 5 Media has not been formatted.
→Format the USB flash memory device or media after making sure on your computer that the USB flash memory or
media you are formatting does not contain important data.
0 0 6 Indicates that the protected song data cannot be loaded.
0 0 7 There is no song data.
There is no file.
0 0 8 The USB flash memory device or media is not connected.
→Connect a USB flash memory device or media to the USB [TO DEVICE] terminal.
0 1 0 The data cannot be saved to internal memory of the instrument.
0 1 1 Data in the USB flash memory hasn’t been restored.
→Press the [PLAY/STOP] button.
0 2 0 This USB flash memory device cannot be used.
→Use only USB flash memory devices compatible with the instrument.
0 2 2 Displayed when the total amount of USB flash memory or USB hub has become too large.
→Refer to “Precautions when using the USB [TO DEVICE] terminal” on page 22.
0 2 3 Indicates failure in connecting the USB flash memory or media.
0 5 1 An error has occurred in the Moving Key function. The [MOVING KEY] status lamp lights in red.
→Please contact your nearest Yamaha dealer or authorized distributor.
0 5 2 The temperature of moving key unit increases. The [MOVING KEY] status lamp flashes in red.
→The instrument is automatically reset.
- - - Processing the current operation.
C L 1 Initializing the voice settings to the normal settings (factory defaults).
C L 2 Initializing the Internet settings to the normal settings.
C L 3 Initializing to the normal settings.
E 5 0 Some abnormality has been detected in the power of the Moving Key function. The [MOVING KEY] status lamp lights in red.
→If this happens, turn off the power to the instrument and disconnect the plug. However, if the [USB] lamp is flashing as
well, turn off the power only after the lamp [USB] lamp is off. Please contact your nearest Yamaha dealer or autho-
rized distributor.
E n d Displayed when the current operation is completed.
F C L Indicates that internal memory has been cleaned up. The backup data in internal memory of the instrument, and voice settings are
cleared, because the power has been turned off before the song save or load operations were completed.
CAUTION
Do not turn off the power of the instrument when “FCL” appears in the display. Doing so may cause the instrument to malfunction.
F U L Displayed when the total amount of files has become too large.
Displayed when internal memory is full.
Displayed when the media is full.
n – y Prompts you to confirm or cancel the overwrite operation.
P r o Indicates that the media is write-protected.