Yamaha H11 - Manual (Page 49)

ENGLISH
Keyboard Stand Assembly
H11 Owner’s Manual
49
Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct direction. Please assemble the unit in
the appropriate sequence.
• Assembly should be carried out by at least two persons.
• Be sure to use the included screws only, and insert screws
of the correct size in the correct hole locations. Do not
use any other screws. Use of incorrect screws can cause
damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly
of each unit.
• To disassemble, reverse the assembly sequence.
1.
Place A on top of the pads.
1-1
Locate two pads (F) so that they will be posi-
tioned about 30 cm inside from the left and right
edges of A.
1-2
Place A on top of the pads.
2.
Raise A to the vertical position.
2-1
Raise A to the vertical position, with the keyboard
side on the bottom, and hold A securely.
CAUTION
Do not tip A further than 90 degrees to avoid stress to the
key cover and lid.
Have a Phillips-head (+) screwdriver ready.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
6 x 30 mm long screws x 4
Before starting installation, remove the vinyl ties that
bundle the pedal cord and AC power cord.
6 x 20 mm short screws x 10
4 x 6 mm small screws x 6
Remove two rectangle pads (800 x 130 mm) from the
packing box.
CAUTION
Be careful not to pinch your
fingers when setting the instru-
ment on the floor.
A
D
E
B
A
C
D
E
B
F
Cord holders x 4
You can attach the included cord holders and tuck
in the LAN cable to suit your setup situation.
A
CAUTION
Do not position the pad under the
control panel.
pads
30 cm 30 cm
A A
CAUTION
Do not release A
until you finish
Step 4.