Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 102)

102
Function Tree/Function List
01X Owner’s Manual
Before Using
Basics Section
Appendix
Getting Started
Reference
CH PAIR (Channel Pair)
q – i
( r )
PAIRED/----
Faders and most parameters of adjacent odd-even channels or Aux buses are
linked for stereo operation. When the channels are linked, the message
“PAIRED” appears. Pairs can also be assigned by simultaneously holding
down the [SEL] button of one channel/bus and pressing the [SEL] button of
the adjacent channel/bus (odd/even numbers). After selecting the desired
channel/bus, you can copy and link parameter values for the odd channels to
the even channels by using channel knobs 1/2. To copy and link parameter val-
ues for the even channels to the odd channels, use channel knobs 3/4. Use
channel knobs 5/6 to assign the two selected channels as a pair and reset both
to their initial default values. The ST IN channels 1/2 cannot be assigned to a
pair with any other channel.
• If you add one channel from a pair to a group, the pair partner is automat-
ically added to the group.
The linked parameters are as follows:
Attenuator, EQ, Dynamics, Channel on/off, Level, Groups, Solo Safe,
Recall Safe, Solo, Aux Send on/off, Aux Send Pre/Post, Aux Send level
Yes
EFFECT [INTERNAL] → [EFFECT] (EFFECT1) → [EFFECT] (EFFECT2) → [EFFECT] (EFFECT1)
EFFECT1/2 PATCH/BYPASS/MIX/TYPE (Effect 2 is 48kHz/44.1kHz mode only)
c
AUX3/4, CH1 – 8,
mL1 – 16
(mL9 – 16 are 48kHz/
44.1kHz mode only),
BUS, STEREO
Determines the signals to be fed to the effects processors. If you select AUX
3/4 and select STI (stereo in channel) 1/2 for the output destination (and if
FX1/FX2 are selected for the stereo input channel 1/2; page 89), this can be
used as a conventional effect send/return. If you select a particular channel,
such as the input channels, REC bus, stereo out, it can be used as an insertion
effect.
• If effects are inserted in channels, you cannot use those effects via Aux
Sends or insert them into other channels.
• The number of inputs and outputs available for each effect varies depend-
ing on the type of effect programs recalled.
• When using an internal effect via the Aux Send, do NOT turn up the send
level to the corresponding AUX bus for the channel to which the effect
return signal is routed. Doing so will result in loud feedback, and may
damage your equipment. For example, when the 01X is in the default
condition, AUX 3 is routed to the input of internal effect 1, and the L/ R
signals of the ST IN channel 1 are routed to the output. If you turn up the
send level of ST IN channel 1 to AUX 3, a feedback loop is created.
No
q
v BYPASS Determines whether or not effects can be bypassed. No
b MIX
When set to 0%, only the dry signal is heard. When set to 100%, only the wet
signal is heard. To mix the effects sound returned via the Aux Sends with the
original dry sound, set the effect’s MIX BALANCE parameter to 100% (only
the effects sound will be output).
No
n TYPE
Indicates the currently-selected effect type. You cannot change the effects
type on this page. To change the effects type, recall a program that uses the
desired effects type from the Effects library (see below).
No
Knob
Function name/
settings
Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]