Yamaha DIGITAL MIXING STUDIO 01X - Manual (Page 59)

01X Owner’s Manual
Mixing Tutorial
59
Before Using
Basics Section
Appendix
Getting Started
Reference
e Press the [SEND] button (several times, if necessary) to
call up the AUX 3 display below.
r Go back to the input channels—press the MIXER/
LAYER [1-8] button.
t Adjust the send level for the desired channel with the
corresponding channel knob.
While you’re adjusting this, listen to the change in the
sound. If you need to, go back to steps 2 and 3 above
and adjust the Return level to an appropriate value.
Remember that you can also select the other channels
(mLAN inputs 9 - 16, and 17 - 24) by pressing the
appropriate button in the MIXER/LAYER section.
(For more about the mLAN inputs, see page 28.)
• For step 5, try pressing the [FLIP] button and using the faders to
adjust the send levels instead of the knobs. (See page 19.)
• If you have little experience in mixing and using effects, you
should keep in mind that the settings you make in each section
above are interrelated—especially the Mix, Aux Return and
Channel Send levels. If any of these are set to – ∞ , you may not
hear any effect sound.
AUX3 SEND LEVEL
-oo -oo
AUX3 SEND LEVEL
-78.0 -68.0 -40.0 -76.0 -oo -oo -oo -oo