Yamaha DIGITAL MIXING STUDIO 01X User Manual
Page 95
01X Owner’s Manual
Function Tree/Function List
95
Before Using
Basics Section
Appendix
Getting Started
Reference
5
mLAN MIDI INFORMATION
z
1 : GENERAL
1 : LOGIC
1 : CUBASE
1 : SONAR
1 : DP (DIGITAL PER-
FORMER)
This page is for display only and the parameters cannot be changed here.
This display shows the settings for each mLAN port. The 01X features five
independent MIDI ports, and the assigned functions are shown here. The set-
tings made in “Remote Select” (page 87) are mirrored here for Port 1, and the
settings made in SHIFT + REMOTE function are mirrored here for Port 5.
1: Remote control of DAW software
2: Direct mLAN connection to MIDI A terminal
3: Direct mLAN connection to MIDI B terminal
4: Data transfer with Studio Manager software
5: SCENE-CTR setting.....For recalling Scenes via program change mes-
sages from an external device, and for transmit-
ting Program Change messages from the 01X
GNRL-RMT .................For remote control of Multi Part Editor software
No
x
2 : MIDI-A
No
c
3 : MIDI-B
No
v
4 : STUDIO.M
(Studio Manager)
No
b
5 : SCENE-CTR
(Scene Control)
5 : GNRL-RMT
(General-Remote)
No
PREFER (Preference) [UTILITY] → Channel knob 7
1
STORE/RECALL CONFIRMATION
v
ON/OFF
Determines whether a confirmation prompt is shown or not for the Store and
Recall operations. When this is set to “OFF,” the corresponding operation is
executed immediately without confirmation.
No
,
ON/OFF
No
2
DIGITAL OUT COPYRIGHT
,
ON/OFF
This setting specifies whether SCMS (Serial Copy Management System) copy
protect data will be enabled (ON) or not (OFF) for the digital signal output
from the DIGITAL STEREO OUT jack. Even if this is set to ON, it will be
possible to digitally record onto a DAT/MD recorder connected to the DIGI-
TAL STEREO OUT jack, but it will not be possible to make second-genera-
tion digital copies.
No
3
DISPLAY SETTINGS
r
PARAM DISP TIME
(Parameter Display
Time)
1 – 5sec
When “Name/Value” (page 17) is set to “NAME,” this determines the amount
of time the currently adjusted parameter value is shown in the display. When
Fader Level Display (below) is set to on, this also determines the time the
Level display is shown.
No
38
,
FADER LEVEL DISP
(Fader Level Display)
Determines whether the Level value is shown or not when a channel fader is
moved.
No
38
Knob
Function name/
settings
Explanation
Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [
/
]