Zebra Technologies 2 - Manual (Page 13)

O-7 UMAN-EN2+
BATTERIES AND CHARGING
Removing and Replacing Batteries
Batteries are removed from the Encore 2 by the follow-
ing procedure:
1. Face the front of the printer. Push the battery
release button on the right side of the printer down as
indicated by the arrow.
2. Firmly slide the battery pack out of the printer until
it is clear while still pressing the battery release but-
ton.
Batteries are replaced by the following procedure:
1. Align the battery pack to the printer so that the
battery contacts (the metal plates on the top of the
battery) are oriented towards the front of the printer.
2. Slide the pack into the printer until it latches with a
distinct “click”.
Conditioning
IMPORTANT
Encore 2 batteries must be cycled a minimum of three
times before maximum capacity is realized. A battery is
cycled by fully charging, then fully discharging it through
normal use.
Battery Release
Latch (push “down”
to release)
E
NCORE
2 B
ATTERY
I
NSTALLATION
Battery Charge
Jack