Zebra Technologies 2 - Manual (Page 17)

O-11 UMAN-EN2+
continued next page
INSTALLATION OF MEDIA
The Encore 2 can print continuous batches of labels or
print and separate labels automatically using its built in
label peeler. The following details how media installation
for these two modes.
Peeler not in use
(Journal, linerless, or batch quantities of labels)
1. Turn unit off.
2. Press and hold the “Open” button on the front of the
unit. Rotate the top back to reveal the paper compart-
ment
3. Remove the edge guide and install the paper roll on
the spindle. Lead the free end over the rubber roller
(platen). Paper should feed from the top of the paper
roll.
4. Slide the edge guide back over the spindle and
against the roll of media. Roll should be against the
inside wall of the paper compartment.
5. Close the top and insure it is securely latched before
beginning to print.
Peeler in use
(Do not use the label peeler when printing a batch quantity
of labels)
1. Turn unit off.
2. Press and hold the “Open” button on the front of the
unit. Rotate the top back to reveal the paper compart-
ment
3. Remove the edge guide and install the paper roll on
the spindle. Lead the free end over the rubber roller
(platen). Paper should feed from the top of the paper
roll.
4. Lift peeler assembly by depressing “Open” button on
front of unit. Lead edge of stock over the peeler bar
and under the grooved peeler roller. Stock should
emerge from the slot in the front cover.