Zebra Technologies 2 - Manual (Page 14)

O-8 UMAN-EN2+
Chargers
Listed below are the specifications for the Encore 2
chargers:
UCN72-4: (p/n series AC15482-tab)
(Part numbers will vary depending on specific country of
use. Consult factory for complete part numbers.)
This charger is designed to charge up to four batteries
simultaneously. Battery packs may be charged sepa-
rately or while plugged into the printer. Typical charge
time is 90 minutes. Switch selectable 110/220 V.A.C.
input voltage. Supplied with line cords compatible
with most international standards.
Do not attempt to charge batteries while printing.
Attempting to print while charging batteries with the
UCN72-4 Charger can result in unreliable charging.
UCN72: (p/n series AT15244-tab)
(Part numbers will vary depending on specific country of
use. Consult factory for complete part numbers.)
UC72N is a wall mounted single charger with univer-
sal 110 to 230, 50-60 Hz. VAC input. Multiple plug
configurations comply with most international stan-
dards.
Do not attempt to charge batteries while printing.
Attempting to print while charging batteries with the
UC72N charger can result in unreliable charging.
Low Battery Shutdown
The Encore 2 monitors battery charge level in software
and will cause the Power LED to flash as the batteries
become depleted. The printer should be shut off and the
battery pack recharged. The printer will automatically
shut itself off if the batteries become severely discharged.
The optional real time clock will maintain its settings
for approximately fifteen minutes while batteries are
being replaced.