Xerox DocuMate 632 - Manual (Page 19)

Installation
14 DocuMate 632 Scanner User’s Guide
3. Turn on the power switch, located on the back of the scanner to
the left of the power port.
The status light comes on and flashes indicating that the
scanner is receiving power.
If you are using Windows XP Service Pack 2 or Windows Vista,
and have plugged the USB cable into a USB 1.1 port, an
information bubble may open explaining that “A HI-SPEED
USB device is plugged into a non-HI-SPEED USB hub”. Plug
the USB cable into a USB 2.0 port (if available) or just
disregard the message. If you leave it plugged into the USB 1.1
port, your scanner may scan a bit slower than the 35 pages per
minute, and 70 images per minute available with a USB 2.0
port.
4. Your computer then recognizes that a scanner has been
plugged into the USB port and automatically loads the
appropriate software to run the scanner.
Do not proceed until you receive a message that your computer
has found the new hardware, or updated the driver database. If
your computer is running Windows XP or Windows Vista, you
will see a message similar to the following.