Yamaha CLP-230 - Manual (Page 27)

Selecting & Playing Voices
CLP-240/230 Owner’s Manual
ENGLISH
27
3.
Select a voice for the right hand.
Press a voice button.
4.
Select a voice for the left hand.
Press the corresponding voice button while holding the [SPLIT] button. (The
indicator of the Left Voice button will light while the [SPLIT] button is pressed.)
To turn the variation on or off for the split voice, hold the [SPLIT] button and
press the [VARIATION] button or the currently-selected voice button.
5.
Exit Split mode and return to normal play mode.
Press the [SPLIT] button again so that its indicator goes out.
NOTE
[VARIATION] in Split Mode
You can turn the variation on or off
for Split mode voices. Normally,
the voice indicator of the right
voice lights in Split mode. The
[VARIATION] can be used to turn
the variation for the right voice on
or off as required. While the
[SPLIT] button is held, however,
the voice indicator of the left voice
lights. In this state the
[VARIA-
TION] button turns the variation
for the left voice on or off.
NOTE
[REVERB] in Split Mode
The reverb type assigned to the
right voice will take priority over
the other. (If the reverb is set to
OFF, the left voice’s reverb type
will be in effect.) Reverb depth
setting via the panel controls (i.e.
pressing the
[–/NO] or [+/YES]
buttons while holding the
[REVERB] button — see
page 21) will be applied to the
right voice only.
NOTE
[EFFECT] in Split Mode
Depending on the conditions, one
effect type will take priority over
the other. The depth will be
decided according to the depth
default value of the voice combi-
nation. However, using function
F4 (page 50) you can change the
depth value for each voice as you
like. Effect depth setting via the
panel controls (i.e. pressing the
[–/NO] or [+/YES] buttons while
holding the [EFFECT] button —
see page 22) will be applied to
the right voice only.