Yamaha CLP-230 - Manual (Page 56)

Connections
CLP-240/230 Owner’s Manual
ENGLISH
56
Connections
Connectors
CAUTION
Before connecting the Clavinova to other electronic components, turn off the power to all the components. Before turn-
ing the power on or off to all components, set all volume levels to minimum (0). Otherwise, electrical shock or damage to
the components may result.
1 AUX OUT [R] [L] Pin jacks (LEVEL FIXED)
You can connect these jacks to a stereo system to amplify the Clavinova or to a cas-
sette tape recorder to record your performance. Refer to the diagram below and use
audio cables to make the connections.
CAUTION
When the Clavinova’s AUX OUT jacks are connected to an external audio system, first turn on the
power to the Clavinova, then to the external audio system. Reverse this order when you turn the
power off.
USB
TO DEVICE TO HOST MIDI
IN OUT THRU
AUX IN
L/L+R R
AUX OUT
(LEVEL FIXED)
R L
USB
TO HOST
AUX IN AUX OUT
(LEVEL FIXED)
L/L+R R R L
MIDI
IN OUT THRU
5
5
1
1
2
2
4
4
3
CLP-240
CLP-230
USB TO DEVICE
SELECT
3
(on the left of the panel)
NOTE
Use audio cables and adaptor
plugs with no resistance.
NOTE
The Clavinova’s [MASTER VOL-
UME] slider setting does not
affect the signal output from the
AUX OUT (LEVEL FIXED) jacks.
NOTE
When the sound from the AUX
OUT jacks is routed to the AUX IN
jacks, the input sound will be out-
put from the speaker of the CLP.
The output sound may be exces-
sively loud and may cause noise.
Stereo
RCA pin plug RCA pin plug
audio cable
Clavinova
AUX IN AUX OUT
AUX OUT
(LEVEL FIXED)
R L
When these are connected (with RCA pin plug; LEVEL FIXED), the sound
is output to the external device at a fixed level, regardless of the [MASTER
VOLUME] slider setting.