Zanussi ZGF 692 CT - Manual (Page 7)

7
INSTALLATION
Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered
competent person, and in accordance with existing rules and
competent person, and in accordance with existing rules and competent person, and in accordance with existing rules and competent person, and in accordance with existing rules and competent person, and in accordance with existing rules and
regulations.
regulations. regulations. regulations. regulations.
The relevant instructions are to be found in the second section of this
manual.
Please, ensure that, once the hob is installed, it is easily accessible for
the engineer in the event of a breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective
materials, which were put on in the factory.
The manufacturer will not accept liability, should the above instructions or
any of the other safety instructions incorporated in this book be ignored.
Instructions for the User Instructions for the User Instructions for the User Instructions for the User Instructions for the User
Lighting the burners Lighting the burners Lighting the burners Lighting the burners Lighting the burners
For easier lighting, proceed before putting For easier lighting, proceed before putting For easier lighting, proceed before putting For easier lighting, proceed before putting For easier lighting, proceed before putting
a pan on the pan support.
a pan on the pan support. a pan on the pan support. a pan on the pan support. a pan on the pan support.
To light a burner:
#
turn the relevant knob anti-clockwise to maximum
position ( ), then push it down to ignite the
burner.
Only for model ZGF 692 CT
#
Upon ignition, keep the knob pushed down
about 5 seconds
5 seconds 5 seconds 5 seconds 5 seconds. This will allow the
"thermocouple" (Fig. 1 - letter D) to be heated
and the safety device to be switched off,
otherwise the gas supply would be interrupted.
#
Then adjust the flame as required.
If the burner does not ignite, turn the control knob
to zero, and try again.
If you cannot light the flame even after
severalattempts, check the "cap" (Fig. - lett. A
A A A A)
and the"crown" (Fig. - lett. B B B B B) are in the correct
position.
Operation Operation Operation Operation Operation
!
A A A A A - Burner cap
B
B B B B - Burner crown
C
C C C C - Ignition electrode
D
D D D D - Thermocouple (only in
model ZGF 692 CT
)
A
B
C
Triple crown burner
(mod. ZGF 692 C/CT)
D