Yamaha F10 - Manual (Page 33)

ENGLISH
Selecting & Playing Voices
F11/F01 Owner’s Manual
33
3
Select a voice for the right hand.
Press a voice button.
4
Select a voice for the left hand.
Press the corresponding voice button while holding the [SPLIT] button. (The
indicator of the Left Voice button will light while the [SPLIT] button is pressed.)
You can make the following settings for right and left voices in Split:
Split Balance
While holding down the [METRONOME] button, press one of the F
#
5-F
#
6
keys (see Quick Operation Guide). The current balance setting appears on the
display while both controls are held. A setting of “0” produces an equal balance
between the two Split mode voices. Settings below “0” increase the volume of
the left voice in relation to the right voice, and settings above “0” increase the
volume of the right voice in relation to the left voice.
Octave Shift
You can shift the pitch up and down in octave steps for the right voice and left
voice independently. You should make the setting depending on the note range
of the songs you play. While holding down the
[METRONOME] button, press
one of the A4-D5 keys (see Quick Operation Guide). The current Octave Shift
setting appears on the display while both controls are held.
Left Voice Reverb Depth (F11)
While holding down the [METRONOME] button, press one of the F
#
1-F2 keys
(see Quick Operation Guide). The current Reverb Depth setting appears on the
display while both controls are held.
Damper Pedal Range
The Damper Pedal Range function determines whether the damper pedal
affects the right voice, the left voice, or both the left and right voices in Split
mode. While holding down the
[BGM] button, press one of the C0-D0 keys (see
Quick Operation Guide). The current range setting appears on the display while
both controls are held.
5
Exit Split mode.
Press the [SPLIT] button again so that its indicator goes out.
TIP
[VARIATION] in Split Mode
You can turn the variation on or
off for Split mode voices. Nor-
mally, the voice indicator of the
right voice lights in Split mode.
The [VARIATION] can be used
to turn the variation for the right
voice on or off as required.
While the [SPLIT] button is
held, however, the voice indica-
tor of the left voice lights. In this
state the [VARIATION] button
turns the variation for the left
voice on or off.
TIP
[REVERB] in Split Mode
The Reverb Type (page 35)
assigned to the right voice will
take priority over the other. (If
the reverb is set to OFF, the left
voice’s Reverb Type will be in
effect.)
TERMINOLOGY
Normal setting:
Balance will be decided accord-
ing to the balance default value
of the voice combination.
TERMINOLOGY
Normal setting:
Octave will be decided accord-
ing to the octave default value of
the voice combination.
TERMINOLOGY
Normal setting: F2
Left voice Reverb Depth will be
decided according to the left
voice Reverb Depth default
value of the voice.
TIP
The normal setting of Damper
pedal range is “for the right
Voice”.
Right Voice
A4 -1
Left Voice
C5 -1
A
#
4 0 C
#
5 0
B4 +1 D5 +1
C0 for the left Voice
C
#
0 for both voices
D0 for the right Voice