Zephyr EOT-E42ASX - Manual (Page 11)

11
www.zephyronline.com
c. Install a 8” exhaust duct and extend length = S - 16“
5/8 from ceiling. Duct shall be securely fastened to
joists. Do not use duct smaller than specified.
Attention: Duct installation is not required for non-
vented (recirculating) installations
d. Install 1/2" electrical conduit in location marked on
template and extend length = S - 11“ 1/8 from
ceiling.
Note: If a Remote ventilator installation is required/
needed, then provide an additional hole/conduit.
e. Install drywall around duct and conduit; then refinish
ceiling, leave enough clearance for easy installation
of chimney structure up to ceiling (see Installation
step 6).
f. Tape Template in place and fit 4 screws on mounting
holes, do not tighten but leave a space of 1/2“,
remove the template.
3. Regulate chimney structure according dimension S
(see step 1) and fix all assembly parts with 4 screws
to each bracket (32 screws in total - 8 already in
place , 24 to be screwed in), check structure is well
assembled.
5
Total 8 x 4 screws
4
1
2
3
6
7
8
FRONT
4. For non-vented (recirculating) installations ONLY:
Fix the deflector on the chimney structure.
5. Note: disregard this step if is intended to install
a remote ventilator.
Purchase and install the Integral ventilator (see
paragraph „Before installing the hood - Parts
not supplied“ for model reference).
6. Raise chimney structure up to ceiling (keep 1/
2“ conduit and 8“ duct inside the proper
passage), use the 4 screws (see step 2/e and 2/
f) to hang the hood.
Note: Chimeny structure front corresponds to
side with electronic box.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other
injury.
Make final angular adjustment to structure at
ceiling if necessary then securely tighten 4
ceiling lag screws.
Fit two additional screws for definitive fixing.
Lag
screws
Lag
screws
Definitive
fixing
Conduit
passage
Duct
passage
7. Connect ducting to transition. Seal with duct
tape.
Do not use duct smaller than the transition.
For Ductless - recirculating - installations only:
provide and install a duct to connect hood transition
to deflector (the deflector is available as an extra
kit).
Inst
allation