ZyXEL Communications P-334U - Manual (Page 103)

P-334U/P-335U User’s Guide
Chapter 6 WAN 103
6.4 Advanced WAN Screen
To change your ZyXEL Device’s advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.
Private This parameter determines if the ZyXEL Device will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private and
not included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
DNS Servers
First DNS Server
Second DNS Server
Third DNS Server Select From ISP if your ISP dynamically assigns DNS server information (and
the ZyXEL Device's WAN IP address). The field to the right displays the (read-
only) DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the
DNS server's IP address in the field to the right. If you chose User-Defined,
but leave the IP address set to 0.0.0.0, User-Defined changes to None after
you click Apply. If you set a second choice to User-Defined, and enter the
same IP address, the second User-Defined changes to None after you click
Apply.
Select None if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a computer in order
to access it.
WAN MAC Address The MAC address section allows users to configure the WAN port's MAC
address by either using the ZyXEL Device’s MAC address, copying the MAC
address from a computer on your LAN or manually entering a MAC address.
Factory default Select Factory default to use the factory assigned default MAC Address.
Clone the computer’s
MAC address
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning. Once it is
successfully configured, the address will be copied to the rom file (ZyNOS
configuration file). It will not change unless you change the setting or upload a
different ROM file.
Set WAN MAC
Address
Select this option and enter the MAC address you want to use.
Apply Click Apply to save your changes back to the ZyXEL Device.
Reset Click Reset to begin configuring this screen afresh.
Table 33 PPTP Encapsulation
LABEL DESCRIPTION