Xantrex Technology SW Series - Manual (Page 131)

TECHNICAL INFORMATION
 2001 Xantrex Technology, Inc.
5916 - 195th Street N. E.
Arlington, WA 98223
Telephone: 360/435-8826
Fax: 360/435-2229
www.traceengineering.com
SW Series Inverter/Charger
Part No. 2031-5
Rev. C: February 2001
Page
123
USER SETTINGS WORKSHEETS
Your SW Series Inverter/Charger may have USER and/or SETUP operating settings that are different or
are changed from the standard factory settings. The USER DEFAULT settings are the same for all
models. The SETUP DEFAULT settings are dependent on the specific model of the SW Series
Inverter/Charger. Worksheets are provided for domestic (US) models. Use the following Worksheets to
record your specific USER and SETUP operating settings for:
SW Series Inverter/Charger – Model SW , S/N .
USER MENU
MENU HEADING MENU ITEM
SELECTION
RANGE
DEFAULT
SETTINGS
USER
SETTINGS
Inverter Mode 1 Set Inverter OFF SRCH ON CHG OFF
Generator Mode 2 Set Generator OFF AUTO ON EQ OFF None
Gen Under/Over Speed DISPLAY NO None
Generator Start Error DISPLAY NO None
Generator Sync Error DISPLAY NO None
Gen Max Run Time Error DISPLAY NO None
Load Amp Start Ready DISPLAY NO None
Voltage Start Ready DISPLAY NO None
Exercise Start Ready DISPLAY NO None
Trace Engineering 3 Revision 4.01 DISPLAY None
Meters 4 Inverter/Charger Amps AC DISPLAY 00 None
Input Amps AC DISPLAY 00 None
Load Amps AC DISPLAY 00 None
Battery Actual Volts DC DISPLAY Battery Volts None
Battery TempComp Volts DC DISPLAY Battery Volts None
Inverter Volts AC DISPLAY 00 None
Grid (AC1) Volts AC DISPLAY 00 None
Generator (AC2) Volts AC DISPLAY 00 None
Read Frequency Hertz DISPLAY 60 None
Error Causes 5 Over Current DISPLAY NO None
Transformer Overtemp DISPLAY NO None
Heatsink Overtemp DISPLAY NO None
High Battery Voltage DISPLAY NO None
Low Battery Voltage DISPLAY NO None
Low AC Output Voltage DISPLAY NO None
Manual Off DISPLAY NO None
AC Source Wired to Output DISPLAY NO None
External Error (Stacked) DISPLAY NO None
Generator Start Error DISPLAY NO None
Generator Sync Error DISPLAY NO None
Gen Maximum Run Time Error DISPLAY NO None
Gen Under/Over Speed DISPLAY NO None
Time of Day 6 SET HR/MIN/SEC 00:00
Generator Timer 7 Start Quiet Time H:M 00:00 – 23:59 08:00
End Quiet Time H:M 00:00 – 23:59 08:00