Zebra Technologies T402 User Manual

Page 13

Advertising
background image

2. Insert one end of the media hanger into one of the media supply guides

(refer to Figure 4).

3. Place the roll of media onto the media hanger.
4. Place the second media supply guide onto the other end of the media

hanger (refer to Figure 4).

NOTES: The media roll must be centered on the media hanger.
The media roll should rest against the smooth side of the media
supply guides. The textured side marked “out” should face the
outside of the printer. The media supply guides should just touch
the edges of the roll of media; they must not cause pressure or
excessive drag on the media roll.

5. Refer to

Figure 5

. If you are using labels, make sure the media

unwinds from the top of the roll. Tags unwind from the bottom of the
roll.

6. Place the media roll in the top cover (refer to

Figure 6

).

7. Release the printhead by pulling the printhead release lever toward you

(refer to

Figure 6, “1”

).

8. Lift the printhead (refer to

Figure 6, “2”

) until you feel it “lock” into

place. Be careful not to force the printhead past this position!

6

1

2

3

Smooth Side of

Media Supply Guide

Media

Hanger

Media

Supply

Guide

Textured

Side

Marked

"OUT"

Figure 4

Advertising