Zebra Technologies T402 - Manual (Page 19)

8. Refer to Figure 13. Thread the media through the media guides.
NOTE: If the media guides must be changed to accommodate the
width of the media, turn the green media guide adjuster (refer to
Figure 13). The media guides should just touch, but not restrict,
the edges of the media roll.
9. Continue to thread the media until it is approximately 8” (203 mm) past
the peel bar (refer to Figure 13).
10. Place the media hanger into the two mounting slots (refer to Figure 14 ).
11. Remove approximately 6” (152.4 mm) of labels from the backing.
12. Insert the label backing into the peel-off feed slot (refer to
Figure 15 ).
Continue to feed the label backing until it comes out of the bottom slot.
12
Media
Guide
Adjuster
Media
Guides
Peel Bar
Figure 13