Parallel interface requirements, Serial and parallel cabling requirements, The back of the printer (refer to – Zebra Technologies T402 User Manual
Page 35: Figure 31, The other end of this serial
Parallel Interface Requirements
The required cable (IEEE 1284-compliant is recommended) must have a
standard 36-pin parallel connector on one end, which is plugged into the
parallel port located on the back of the printer (refer to Figure 31). The
other end of the parallel interface cable connects to the printer connector at
the host computer.
For
, refer to page 52.
Serial and Parallel Cabling Requirements
Data cables must be of fully shielded construction and fitted with metal or
metalized connector shells. Shielded cables and connectors are required to
prevent radiation and reception of electrical noise.
To minimize electrical noise pickup in the cable:
n
Keep data cables as short as possible (6’ [1.83 m] recommended).
n
Do not tightly bundle the data cables with power cords.
n
Do not tie the data cables to power wire conduits.
28
Connects to
Parallel Port on
Host Computer
Parallel
Port
Serial
Port
Connects to
Serial Port on
Host Computer
Figure 31