Zebra Technologies R170XiTM - Manual (Page 141)

Troubleshooting
LCD Error Messages
23063L-003 Rev. 2 12/23/04 R110Xi/R170Xi User Guide 129
HEAD COLD
Caution • An improperly connected printhead data or power cable can
cause this error message. The printhead can still be hot enough to cause
severe burns. Allow the printhead to cool.
The printhead is under
temperature. Continue printing while the printhead reaches the
correct operating temperature. If the error remains,
the environment may be too cold for proper
printing. Relocate the printer to a warmer area.
Printhead data cable is not
properly connected.
Caution • You must turn off the printer before
performing this procedure. Failure to do so can
damage the printhead.
1. Turn off ( O ) the printer.
2. Disconnect and reconnect the data cable to the
printhead.
3. Ensure that the cable connector is fully
inserted into the printhead connector.
4. Turn on ( I ) the printer.
Caution • Observe proper electrostatic
safety precautions when handling any
static-sensitive components such as
circuit boards and printheads.
OUT OF MEMORY There is not enough memory to
perform the function shown on
the second line of the error
message. Turn the printer off then back on to clear memory,
and try to print again. If the error recurs, there is
insufficient memory for the label length,
downloaded fonts or graphics, and images.
Ensure that the device, such as Flash memory or
PCMCIA card, is installed and not write-protected
or full. See
Memory Cards on page 109 .
Caution • Observe proper electrostatic
safety precautions when handling any
static-sensitive components such as
circuit boards and printheads.
Ensure that the data is not directed to a device that
is not installed or available.
Table 14 • LCD Error Messages (Continued)
LCD Possible Cause Recommended Solution